Skip to main content

Pinball Scavenging

I purchased a little while ago the worst pinball machine playfield ever: Williams' Hardbody.  It is considered to be one of the worst pinball machines ever made and that's why it was cheap!  I'm scavenging usable parts from it.  Drop targets, raised ramps, ball savers, you get a little bit of everything from the playfield.  I also got Laser Ball, an average pinball playfield.

Bally HardBody

Williams Laser Ball























 This is by far and away the cheapest way to get parts.  I paid $200 for both playfields and considering that even used pop bumpers can cost $30 so it was well worth it.  I'll likely have a ton of parts left over from my project in the future but if anyone wants to buy an unpopulated playfield let me know. The Laser Ball playfield is actually in good condition but is just rather dirty from being stored for so long.  I've also kept the non-broken plastics. 
Labels:

Comments

Post a Comment

Popular posts from this blog

MOSFET Driver Board

Final version?  I hope so.  I have gone back and redesigned my solenoid driver board several times.  In previous versions I attempted to offload some of the logic from the microcontroller.  For example, I used a Schmitt-Trigger [74HC14] with an RC network to provide a single pulse to the solenoid.  Also, I added in a PWM signal to set the average voltage 'seen' by the solenoid.  This worked but was very limiting to have the pulse length hardwired in and it was difficult to adjust without more expensive precision potentiometers. I chose to simplify my circuit to make it a general MOSFET driver for flexibility.  Since I have more than enough space inside my pinball cabinet, it was not a problem to have the extra boards.  The boards were designed to have 4-channels since by default I would get a minimum of 10 boards for the same price from Seedstudio.  Also, the cheapest board option was restricted to 10cm x 10cm otherwise the price balloons ...
3 comments
Read more

Pinball Cabinet Beginnings

I was getting to the point where I really needed to build on something. I have numerous pinball parts but have nothing to attach them to. I managed to find some pinball plans for a Williams Widebody pinball machine. All the measurements are in mm sadly even though all pinball cabinets are in inches. I converted and change it all to the nearest quarter inch. Well sort of. The guy who measured this was intending on using 45 deg cuts in the corners. My skill saw is too cheap for that so I changed the measurements for butted joints. The interior is set for a 23.5" wide playfield. The length of the cabinet is 51.5" in total. I used 3/4 inch plywood so the bottom would be 50" long for example. You can pretty much dimension the rest from there.  I did get a little chipping of the plywood but I went out and bought a blade with more teeth for finer cuts. It's a 60 tooth saw blade and my skill saw doesn't really have enough power for it so I have...
Post a Comment
Read more

ATX Breakout Board

Last November, I fried my 'lab power supply' that I made from a computer PSU.  I was testing my solenoids and the stress was just too much for the PSU.  The mistake I made was rapidly turning on and off my solenoid which likely resulted in voltage transients (spikes).  Since the PSU does have a current limiter, it was likely the constant voltage spikes that caused the damage.  There are various methods to suppress voltage transients such as by-pass capacitors and zener diodes.  In particular solenoids and other inductive loads experience these voltage spikes, hence my no longer functioning bench power supply. ATX Breakout Board I could have just rebuilt the same power supply by adding binding posts etc to the PSU housing but after searching the internet an ATX power supply breakout board seemed a popular option.  The main advantage compared to my old power supply was the addition of fuses on the outputs.  The extra safety this provides is perf...
Post a Comment
Read more